Custom Silicone Apollo Ram Air Intake with Heat Reflective Tape

New Custom Ram Air Intake – I was going to wait until i installed the amazing heat reflective tape I found, but since it’s a bit unusual, I’ll update that in it’s own post. Currently, I have a K&N typhoon CAI, and I installed the HPSI Ram air tube last summer, and I was playing around with a ram air intake system. I found a 45º silicone coupler, and was able to match it up with a universal K&N Apollo filter I found for CHEAP on ebay. I plugged the hole on the new Apollo, and get the temp readings from the same bung on the K&N. The Apollo sits right in the RAM air tube, just like the HPSI intake. This filter is quieter than the K&N, so you’re not always hearing that much turbo “flutter” sound that some have thought to sound like actual turbo flutter. Now the blow off sound is more pronounced, as I drilled out the Forge plate a bit more, and this is now pulling air from down below and through the front grill. Since I’ve put in a open mesh up there, I’m hoping to get as much air flow as possible.

I also like the large K&N heat shield, and I wanted to keep that as well, for more heat reflection. I removed it, and used a sawzall to cut the bottom out, to make room for the filter down there. I was still able to bolt it on from the top.

20160501_162826
20160501_162832
20160507_170938
20160507_170947
20160507_170955
20160507_171005
20160317_075412
20150820_185215
20150821_220810
20150821_220819

*heat reflective tape information below*
Next up – custom RAM air is now finished. Here is a better view of the Apollo filter joining with the HPSI Ram air tube. I pressed two small holes on the top of the tube, and used tie-wraps to secure it to the metal frame bracket. This gave me a better, more solid, connection, and I didn’t have to spend all the $$ on their intake. As mentioned earlier, this is a K&N typhoon intake, with some Yoderian Wizardry. I forgot to take a pic, but I also cut off the top / front of the factory air tube, just inside the front grille, This allows for actual air flow, much like the newer 2014-16 models with the plastic tube.

20160706_004715
20160706_004708

I wrapped the intake with reflective heat wrap. This stuff is 56% more efficient than the cheap ebay gold stuff. I did some research, and this is what many of the racers use (because #racecar not) I purchgased 1 ft (1ft X 15″) which was $33.00 plus shipping, and is called Aerolite-Shield. You can find it at Earls Indy

20160709_094138
20160709_094144
20160709_094149

Tags:
Categories: